Mitutoyo SURFTEST SJ-410 - Selecting the Special Stylus

No. 99MBB765A
13-50
13.19 Selecting the Special Stylus
You can select a special stylus that is not available in the selection field.
IMPORTANT
• To perform arm correction with the special stylus used, you must set the length and
height of the stylus correctly.
NOTE
• If the stylus is detached and attached, or replaced, make sure to perform calibration
Without properly calibrating the instrument, correct measurements can not be obtained.
■ Operating procedure (Refer to 13.1, “■ Accessing the Operating Environment Setup screen”.)
Home screen to Main Menu ⇒ ⇒
Operating Environment Setup screen
1
Touch .
Stylus Select screen
2
Touch .
Stylus Customize screen
3
Touch .