Mitutoyo SURFTEST SJ-410 - Saving Data to the SD Card; Saving Measurement Results to the SD Card

No. 99MBB765A
18-6
18.2 Saving Data to the SD Card
You can save measurement data or screen images to the SD card by pressing .
18.2.1 Saving measurement results to the SD card
You can save measurement data to the SD card when data output is set to "Data storage".
With this setting, measurement data is saved to the SD card when
of the SJ-410 is
pressed. Measurement data is saved in a designated folder in the main folder.
NOTE
• After the power to the instrument is turned on, the first time data is saved may take more
time than usual.
TIP
• The folder with the folder number indicated in blue means it is the main folder.
For information about designating the main folder, refer to "10.4.3 Specifying the main
folder" (page 10-12).
For information about setting the data output, refer to "13.4.2 Setting data output to save
data" (page 13-8).
Main folder display
■ Operation procedure
1 Perform the measurement.
TIP
• For information about measurement, refer to "Chapter 4 MEASUREMENT FLOW"
(page 4-1).
2 Press .
 Measurement data is saved in a designated folder in the main folder.