Mitutoyo SURFTEST SJ-410 - Setting the Data Output to SPC

13. OPERATING ENVIRONMENT SETUP
No. 99MBB765A
13-7
13.4.1 Setting the data output to SPC
You can output calculation results from the SJ-410 to a Input Tool or Digimatic Mini
Processor when data output is set to "SPC".
With this setting made, calculation results are output when
on the SJ-410, or the
[DATA] key (when connected) on the Digimatic Mini Processor is pressed.
NOTE
• The factory default setting for data output is “SPC”.
TIP
• For information about data output with SPC, refer to "18.1 SPC Data Output" (page
18-3).
■ Operating procedure (Refer to 13.1, “■ Accessing the Operating Environment Setup screen”.)
Home screen to Main Menu ⇒
Operating Environment Setup screen
1
Touch .
Data Output Setup screen
2
Touch .