Mitutoyo SURFTEST SJ-410 - Adjustment Using the Tilt Adjustment Unit

No. 99MBB765A
15-20
15.7 Adjustment using the Tilt Adjustment Unit
The tilt adjustment unit is an optional item.
■ Operating procedure (Refer to "■ Accessing the Preliminary Measurement screen" in this chapter.)
Home screen to Main Menu ⇒
Preliminary Measurement Setup screen
1
Touch .
Tilt Adjustment Unit screen
2
Touch [Measurement Conditions] to specify the preliminary
measurement conditions.
TIP
•
For information about setting the preliminary
measurement conditions, refer to "15.2 Modifying
Preliminary Measurement Conditions" (page 15-3).
Tilt Adjustment Unit screen
3
Touch
[Drive Unit Operation] to display the Drive Unit
Operation screen.
Drive Unit Operation screen
4
Move the stylus to the measurement starting position.
Touch the buttons according to the direction and distance to
reposition the stylus.
The movement speed differs depending on the size of the button
you press. The detector moves fastest with the largest button. As
you touch the smaller buttons, the detector moves slower.
Touching moves the stylus toward the origin position.
Touching
moves the stylus away from the origin position.
5 Touch [OK].