Mitutoyo SURFTEST SJ-410 - Turning the Power off

No. 99MBB765A
3-30
3.9.3 Turning the power off
The following two methods are available for tuning the power off.
• Power off using the [POWER] key
• Power off with auto-sleep in use of the built-in battery
■ Power off using the [POWER] key
Press and hold the [POWER] key to turn the power off. The SJ-410 enters the recharging
mode depending on the recharging progress. The screen turns off when the battery is fully
charged.
[POWER] key
● Power off with auto-sleep in use of the built-in battery
With the built-in battery in use and auto-sleep set to ON, when the SJ-410 is not operated
for more than a constant time, the power is automatically turned off with the auto-sleep
function.
Even if the power is turned off by the auto-sleep function, the measurement conditions and
results are retained and will be displayed on the display the next time the power is turned
on.
NOTE
• When the AC adapter is used, auto-sleep does not function irrespective of the setting of
the auto-sleep function. To turn off the SJ-410 power, press and hold the [POWER] key
until the power is turned off.
TIP
• For information about setting the auto-sleep function, refer to "13.13.1 Setting the
auto-sleep function" (page 13-40).
[POWER] key