Mitutoyo SURFTEST SJ-410 - Returning; Auto-Return

No. 99MBB765A
5-4
5.2.3 Returning
After measurement, you can return the detector manually to the measurement starting
position. When the auto-return function is not enabled, the button appears after
measurement. When the auto-return function is enabled, the button does not appear.
■ Operating procedure (Refer to 5.1 "■ Accessing the Drive Unit Operation screen".)
Home screen ⇒
Drive Unit Operation screen
1
Touching [Return] moves the detector towards the
measurement starting position.
 The detector is repositioned to the measurement starting
position.
5.2.4 Auto-return
After measurement, you can return the detector automatically to the measurement starting
position.
Enable or disable the auto-return (the operation automatically returning the detector to the
measurement starting position after the completion of measurement). When measurement is
started, (1) the main measurement is started. When the auto-return function is ON, (2) the
detector is returned from the main measurement completion position to the measurement starting
position.
Auto-returning operation
NOTE
• When the auto-return function is set OFF, the detector cannot be returned to the
measurement starting position automatically.
• If an error, such as accidental error, occurs during the auto-return, the return
operation is stopped. Then, the return key becomes inactive. Reset the error and
manually move the detector to the measurement start point.
(2)
(1)