Mitutoyo SURFTEST SJ-410 - Operation Using the SD Card; Loading the Condition File

9. CONDITION FILE
9.3 Operation using the SD Card
IMPORTANT
• When using the built-in battery, make sure it is sufficiently charged. If the SJ-410 gains
access to the card when the level of the battery remainder power is low, the power of
the SJ-410 may be turned off during accessing.
• Do not insert or remove the SD card while the SJ-410 is gaining access.
9.3.1 Loading the condition file
The saved condition file on the SD card can be loaded.
9.3.1.1 Loading the condition file
■ Operating procedure (Refer to 9.1 "■ Accessing the Condition File Menu screen".)
Home screen to Main Menu ⇒ ⇒
Condition File Menu screen
1 Touch .
Condition File Load screen
2 Touch the condition file to be loaded.
If the condition file to be loaded is not displayed, touch
/ / / to display the condition file.
3 Touch .
To cancel loading of the condition file, touch
.
Condition File Load screen
¾ The condition file is loaded and the Home screen is displayed.
TIP
• On the message screen, following information is
displayed.
•
Display the target file name.
•
Display a comment if it is entered in the file.
• For information about entering a comment, refer to
"
9.3.2.1 Saving the condition file newly" (page 9-9).
No. 99MBB765A
9-7