Mitutoyo SURFTEST SJ-410 - Modifying Preliminary Measurement Conditions; Modifying the Measurement Conditions

15. PRELIMINARY MEASUREMENT (AUXILIARY FUNCTIONS)
No. 99MBB765A
15-3
15.2 Modifying Preliminary Measurement Conditions
This section explains how to set the following measurement conditions for preliminary
measurement. The procedure for adjusting the tilt of the drive unit using the height/tilt
adjustment unit is used as an example.
• Switching the measurement conditions • Measurement length
• Traversal speed • Returning speed
• Measurement range • Auto-start
• Auto-return • Retraction
15.2.1 Modifying the measurement conditions
The measurement conditions used in preliminary measurement can be switched.
■ Operating procedure (Refer to "■ Accessing the Preliminary Measurement screen" in this chapter.)
Home screen to Main Menu ⇒
⇒
Drive Unit Tilt Adjust screen
1
Touch [Measurement Conditions].
Preliminary Measurement Conditions
Setup screen
2
Set the preliminary measurement conditions.
TIP
•
The measurement conditions for the preliminary
measurement can be set independently, without
influencing the normal measurement conditions.
Preliminary Measurement Conditions
Setup screen
3 To perform the preliminary measurement under the same
conditions as the normal measurement, touch [Copy
Measurement Conditions].
 Touching
copies the normal measurement conditions
to the preliminary measurement conditions.
TIP
• The measurement conditions not included in the setup
item for the preliminary measurement conditions are
not copied.
• If preliminary measurement is aborted, calculation for
preliminary measurement is performed using the valid