Mitutoyo SURFTEST SJ-410 - Displaying the Calculation Results Depending on Use; Saving;Loading the Conditions To;From the Internal Memory; Saving Measurement Results Automatically

17. USEFUL FEATURES OF THE SJ-410
No. 99MBB765A
17-3
17.5 Displaying the Calculation Results Depending on
Use
Display of the calculation results can be switched depending on use. Example of display is
shown below.
For information about switching display, refer to "14.3.1 Switching the calculation results
display screen" (page 14-4).
1-column display
Waveform display
4-column display Trace display
17.6 Saving/Loading the Conditions to/from the
Internal Memory
The SJ-410 can save the condition files up to 10 cases of measurements to the internal
memory. The saved files can be loaded. For information about saving/loading the
condition files, refer to "Chapter 9 CONDITION FILE" (page 9-1).
17.7 Saving Measurement Results Automatically
When the Save10 function is enabled, measurement results can be saved on the SD card
automatically.
Measurement results are saved in the SD card's Save10 folder. To load the measurement
results, select the “Read10Data” on the Measurement Result Menu screen.
Measurement Result Menu screen
You can save, print and recalculate the loaded results in the same way as the usual
measurement results.