Mitutoyo SURFTEST SJ-410 - Setting the Display of the Setting Conditions

14. SWITCHING THE CALCULATION RESULTS SCREEN
14.4 Setting the Display of the Setting Conditions
This section explains the setup whether to display the settings such as the calibration date,
cumulative distance and data output when turning the power on.
■ Operating procedure (Refer to
14.2 "■ Accessing the Screen Change screen".)
Home screen to Main Menu ⇒
Screen Change screen
1 Touch .
Setting Condition Setup screen
2 Touch the setup item.
The setup item is as follows.
"Display" : Displays the setting conditions.
"No Disp." : Does not display the setting conditions.
3 Touch .
Screen Change screen
¾ The set item appears on the Screen Change screen.
TIP
• Touch [Initialize] to reset all the settings to their
initial values.
¾ After the item is set up, the set screen appears after the power to
the instrument is turned on.
TIP
• For information about the screen displayed at turning
the power on, refer to "
14.1 Screen Display" (page
14-1).
No. 99MBB765A
14-7