Mitutoyo SURFTEST SJ-410 - Setting Calculation Conditions When Mr Is Selected

8. MODIFYING PARAMETERS
No. 99MBB765A
8-11
8.3.3 Setting calculation conditions when mr is selected
If the parameter mr is selected, the number of sections, reference line, and section level
must also be set as calculation conditions.
TIP
• The calculation results for parameter mr are displayed according to the set number of
sections (N).
• Parameters mr(Rz) and mr(Rt) can be set when the roughness standard is “Free”.
■ Operating procedure (Refer to 8.1 "■ Accessing the Parameter Setup screen".)
Home screen to Main Menu ⇒ ⇒
Details Setting screen
1
Touch .
mr Setup screen
2
Set the reference line to be selected.
a Touch .
Reference Line Setup screen
b Input the reference line.
The input range is as follows:
0.0 - 99.9 %
TIP • Touching sets the value to 0.
• For information about numeric value entry, refer to
"2.2.4 Entering numeric values/characters" (page 2-5).