If the measurement falls below the lower limit, the “-NG” sign will appear on the right side
of the parameter name. In addition, the part indicating the measurement result will turn
blue.
GO/NG judgment result (below the lower limit)
NOTE
• The upper limit and lower limit can be set individually. Specifying "0" to the upper limit or
lower limit allows the upper limit or lower limit tolerance judgment function to be
selectively disabled.
TIP
• For information about setting the GO/NG judgment function, refer to "8.3.7 Setting the
GO/NG judgment function" (page 8-20).
4.6.5 Display the results at each sampling length
It is possible to check the measurement results at each specified sampling length and the
GO/NG Judgment results for each parameter.
Measurement results at each
sampling length
Display of measurement results
at each sampling length
TIP
• For information about measurement results at each sampling length, refer to "Chapter
11 CONFIRMING CALCULATION RESULTS BY LIST" (page 11-1).
No. 99MBB765A
4-20
To Next Page
Loading...
