Mitutoyo SURFTEST SJ-410 - Measurement Condition Setup Using Drawing Symbols

7.4 Measurement Condition Setup Using Drawing
Symbols
SJ-410 allows for easy setup of evaluating conditions accordingly to the inspection
conditions shown on the process drawings using symbols.
NOTE
• Only 1 parameter can be used when setting evaluating condition with drawing symbols.
The number of parameters remains the same when the existing evaluating condition is
set with drawing symbols.
If a parameter other than the one already set for an existing evaluating condition is input
with drawing symbols, it will be added on the Evaluating Condition Setup Menu screen.
• When the Evaluating Condition B is turned OFF, drawing symbols cannot be entered.
■ Operating procedure (Refer to
7.2 “■ Accessing the Evaluating Condition Menu screen”)
Home screen to Main Menu ⇒
Evaluating Condition Menu screen
1 Touch on the Evaluating Condition Menu screen.
¾ Drawing Symbol Input screen is displayed.
Roughness standard
Refer to 7.3.1 (page 7-8).
Evaluation profiles
Refer to 7.3.2.1 (page 7-7).
Cut-off length (λs)
Refer to 7.3.2 (page 7-7).
Parameter
Refer to 7.3.3 (page 7-22).
Cut-off length (λc)
Refer to 7.3.2 (page 7-7).
Number of Sampling Length
/Evaluation Length
Refer to 7.3.5 (page 7-25).
Refer to 7.3.6 (page 7-27).
Upper/Lower Limit
Refer to 8.3.7 (page 8-20).
GO/NG Judgment
Refer to 8.3.7 (page 8-20).
Upper/Lower Limit Switch
U: Upper Limit
L: Lower Limit
Refer to 8.3.7 (page 8-20).
Drawing Symbol Input screen
No. 99MBB765A
7-48