Mitutoyo SURFTEST SJ-410 - Modifying the Measurement Length

No. 99MBB765A
15-4
data to continue each adjustment. However, if the data
amount is extremely small, preliminary measurement is
disabled.
･ Preliminary measurement is aborted by the
k ey.
･ Over-range has occurred during preliminary
measurement.
15.2.2 Modifying the measurement length
You can modify the measurement length.
■ Operating procedure (Refer to "■ Accessing the Preliminary Measurement screen" in this chapter.)
Home screen to Main Menu ⇒
⇒
Drive Unit Tilt Adjust screen
1
Touch [Measurement Conditions].
Preliminary Measurement Conditions
Setup screen
2
Touch .
Measurement Length Setup screen
3
Enter the measurement length.
TIP
•
For information about numeric value entry, refer to
"2.2.4 Entering numeric values/characters" (page 2-5).