10 MEASUREMENT
RESULTS
The SJ-410 can save the measurement results. It can also load the
saved data.
10
The SJ-410 can save the measurement results in files and load the saved data. It also can
delete and rename the files.
Note that an SD card is necessary for saving/loading the measurement results.
Using an SD card, the SJ-410 can save the condition files up to 500 cases and the
measurement results up to 10,000 cases of measurements. It can also load the saved
data.
A maximum of 500 cases of measurement results can be saved in each folder. As 20
folders exist, the SJ-410 can save a maximum of 10,000 cases of measurement results.
The folders can be renamed.
IMPORTANT
• When using the built-in battery, make sure it is sufficiently charged. If the measurement
results are loaded when the level of the battery remainder power is low, the power of the
SJ-410 may be turned off during loading the data.
• Do not insert or remove the SD card while the SJ-410 is gaining access.
• For information about precautions for using the SD card, refer to "3.8 Using the SD
Card" (page 3-21).
• The conditions related to optional units and styli cannot be saved and loaded for safety
reasons.
TIP
• A name is automatically generated and displayed, but it can be changed as required.
The name can consist of alphanumeric characters (upper case), "-" (hyphen), and "_"
(underscore). Up to 8 characters can be used.
• For information about character entry, refer to "2.2.4 Entering numeric
values/characters" (page 2-5).
NOTE
• A file name can have at most 8 characters. Refer to "2.2.4 Entering numeric
values/characters" (page 2-5).
• The file name or folder name cannot include lowercase alphabets.
No. 99MBB765A
10-1
To Next Page
Loading...
