18. SAVING AND OUTPUTTING MEASUREMENT RESULTS USING THE [DATA] KEY
No. 99MBB765A
18.1 SPC Data Output
By connecting the SJ-410 to Input Tool (optional accessory) with an SPC cable (optional
accessory), data can be output directly to the PC. The SJ-410 also has the functions for
statistical processing and printing when connected to a Digimatic Mini Processor (optional
accessory). Apart from recent measurements, data saved on the SD card can be loaded
and output with SPC for statistical processing and printing.
IMPORTANT
• Only the calculation results of parameters with the SPC mark ( ) can be output as
SPC data. Parameter names, etc., will not be output.
• When outputting parameter calculation results for statistical processing, take care to not
include data obtained with differing parameters.
An error may occur if multiple pieces of parameter data with differing units and decimal
place positions are output to the Digimatic data processor.
The operation flow of outputting SPC data is described below.
Connecting Input Tool or Digimatic Mini Processor
Executing the actual measurement
of the roughness specimen
→ "Chapter 4 MEASUREMENT FLOW" (page 4-1)
Set calculation result output to “SPC”
→ "13.4.1 Setting the data output to SPC" (page 13-7)
Outputting calculation results
→ "18.1.2 Outputting SPC data" (page 18-5)
When outputting calculation results
When outputting saved data
Loading saved data for output
→ "10.3 Loading Measurement Results
from the SD Card" (page 10-5)
Selecting parameters to output
→ "18.1.1 Selecting parameters" (page 18-4)
To Next Page
Loading...
