Mitutoyo SURFTEST SJ-410 - Setting Calculation Conditions When HSC Is Selected

8. MODIFYING PARAMETERS
No. 99MBB765A
8-9
8.3.2 Setting calculation conditions when HSC is selected
If the HSC parameter is selected, the height of the slice level, a calculation condition, must
be set.
■ Operating procedure (Refer to 8.1 "■ Accessing the Parameter Setup screen".)
Home screen to Main Menu ⇒ ⇒
Details Setting screen
1
Touch .
HSC Setup screen
2
Touch the reference of the count level to be selected.
"Peak": Set from the highest peak of the evaluation profile
"Base": Set from the mean line of the evaluation profile
Sm/Pc/Ppi/Rc Setup screen
 The background of the selected reference of the height of the
slice level becomes blue.
Sm/Pc/Ppi/Rc Setup screen
3
Touch the measurement type of the count level to be selected.