Mitutoyo SURFTEST SJ-410 - Outputting SPC Data

18. SAVING AND OUTPUTTING MEASUREMENT RESULTS USING THE [DATA] KEY
No. 99MBB765A
18-5
18.1.2 Outputting SPC data
You can output calculation results from the SJ-410 to a Input Tool or Digimatic Mini
Processor when data output is set to “SPC”.
With this setting made, calculation results are output when
on the SJ-410, or the
[DATA] button on the Digimatic Mini Processor (when connected) is pressed.
TIP
• For information about setting data output, refer to "13.4.1 Setting the data output to
SPC" (page 13-7).
• You can load saved measurement data and output the calculation results. For
information about loading measurement data, refer to "10.3 Loading Measurement
Results from the SD Card" (page 10-5).
■ Operation procedure
1 Perform the measurement.
TIP
• For information about measurement, refer to "Chapter 4 MEASUREMENT FLOW"
(page 4-1).
2 Press of the SJ-410 or the [DATA] button on the Digimatic Mini Processor
(when connected).
 Calculation results are output to the PC (when connected) via Input Tool, or to
the Digimatic Mini Processor (when connected).