Mitutoyo SURFTEST SJ-410 - Modifying the Preliminary Measurement Conditions

15. PRELIMINARY MEASUREMENT (AUXILIARY FUNCTIONS)
No. 99MBB765A
15-5
Preliminary Measurement Conditions
Setup screen
4
Touch .

The entered measurement length is displayed on the
Preliminary Measurement Condition Setup screen.
TIP
• Touch to return to the previous screen.
15.2.3 Modifying the preliminary measurement conditions
Set the preliminary measurement conditions, such as traversing speed, returning speed,
measurement range, auto-start, auto-return, and retraction, according to the state in which
preliminary measurement is performed.
■ Operating procedure (Refer to "■ Accessing the Preliminary Measurement screen" in this chapter.)
Home screen to Main Menu ⇒
⇒
Drive Unit Tilt Adjust screen
1
Touch [Measurement Conditions].
Preliminary Measurement Conditions
Setup screen
2
Touch / t
o display the preliminary measurement
conditions to be set.
3 Touch the item to be set and specify the preliminary measurement
conditions.
For information about setting each preliminary measurement condition,
refer to the following descriptions.
Setup item
Related section
7.5.1 (page 7-49)
7.5.2 (page 7-50)
7.5.3 (page 7-51)
7.5.6 (page 7-54)
7.5.7 (page 7-55)
7.5.8 (page 7-56)