Mitutoyo SURFTEST SJ-410 - Setting the Self-Timer

13. OPERATING ENVIRONMENT SETUP
No. 99MBB765A
13-41
Timer Setup screen
 The wait time is set and displayed on the Auto-Sleep Setup
screen.
13.13.2 Setting the self-timer
You can set measurement to begin after an amount of time has passed from pressing
.
■ Operating procedure (Refer to 13.1, “■ Accessing the Operating Environment Setup screen”.)
Home screen to Main Menu ⇒ ⇒
Operating Environment Setup screen
1
Touch .
Timer Setup screen
2
Set the self-timer function to ON or OFF.
Touching
cycles through the available settings, "ON"
and "OFF".
"ON": Sets the self-timer function to ON.
"OFF": Sets the self-timer function to OFF.
Timer Setup screen
3
Touch /
to set the amount of time to pass until
measurement starts.
Available range is as follows:
2 to 30 sec (1 sec increments)