Mitutoyo SURFTEST SJ-410 - Self-Timer; Inputting the Diagram Symbols; Printing Environment Setup; Backing up the Main Unit Information

No. 99MBB765A
17-6
17.13 Self-timer
You can set measurement to begin after an amount of time has passed from pressing
with the Self-timer function.
TIP
• For information about setting the self-timer, refer to "13.13.2 Setting the self-timer"
(page 13-41).
17.14 Inputting the Diagram Symbols
SJ-410 allows for easy setup of evaluating conditions accordingly to the inspection
conditions shown on the process drawings using symbols.
TIP
•
For information about inputting the diagram symbols, refer to "7.4 Measurement
Condition Setup Using Drawing Symbols" (page 7-48).
17.15 Printing Environment Setup
You can print the operating environment settings from the SJ-410.
When is pressed while the Operating Environment menu screen is displayed, the
setting items is printed.
TIP
• For more information about printing the environment settings, refer to "13.2 Printing the
Environment Settings" (page 13-4).
17.16 Backing up the Main Unit Information
You can back up the condition settings and measurement results saved in the SJ-410
main unit to the SD card. You can load the data that have been backed up to the SJ-410
main unit.
Backup screen
TIP
• For information about backing up the main unit information, refer to "13.12.8 Backing up
to the SD card and restoring backup data" (page 13-37).