Mitutoyo SURFTEST SJ-410 - Setting X-Axis Operation; Setting the Resume Calculation

7. MODIFICATION OF THE MEASUREMENT CONDITIONS AND EVALUATING CONDITIONS
7.5.9 Setting X-axis operation
Sets the X-axis operation.
■ Operating procedure (Refer to
7.2 “■ Accessing the Evaluating Condition Menu screen”)
Home screen to Main Menu ⇒ ⇒
Measurement Conditions Menu screen
1 Touch on the Measurement Condition Menu
screen.
Touching
cycles through the available settings,
ON and OFF.
When the X-axis operation is set to "OFF", measurement is
performed with the X-axis operation unit stopped.
7.5.10 Setting the resume calculation
After the measurement is cancelled due to errors including over-range, or on purpose, calculation
can be resumed by changing the conditions to enable to calculate with the obtained sampling
data.
IMPORTANT
• The calculation results obtained by resuming calculation are prefixed with a letter “S".
■ Operating procedure (Refer to
7.2 “■ Accessing the Evaluating Condition Menu screen”)
Home screen to Main Menu ⇒ ⇒
Measurement Conditions Menu screen
1 Touch on the Measurement Condition Menu
screen.
Touching
cycles through the available settings,
ON and OFF.
ON：Calculation is performed with the data obtained until the halt of
measurement.
OFF: Calculation is not performed after the halt of measurement.
No. 99MBB765A
7-57