7.8 Saving Measurement Conditions
A set of evaluating/measurement conditions can be saved in the internal memory, or on
the optional SD card.
IMPORTANT
• A new SD card must be formatted with the SJ-410 before it can be used. The memory
card may not function properly when formatted in a device other than the SJ-410. For
information about formatting the SD card, refer to "13.12.3 Formatting the SD card"
(page 13-31).
• When the built-in battery is completely depleted, or the built-in battery switch is set to
OFF, any measurement conditions saved to the internal memory are lost. It is
recommended to make periodic backups to the SD card. For information about backing
up to the SD card, refer to "13.12.8 Backing up to the SD card and restoring backup
data" (page 13-37).
• When using the built-in battery, make sure it is sufficiently charged. If measurement
conditions are saved when the battery power is low, the SJ-410 may shut off while the
data is being saved resulting in save errors.
■ Operating procedure (saving to the internal memory)
(Refer to
7.2 “■ Accessing the Evaluation Condition Menu screen”)
Home screen to Main Menu ⇒
Evaluating Condition Menu screen
1 Touch [Condition Save] on the Evaluating Condition Menu
screen.
Save Folder Select screen
2 Touch , then touch .
No. 99MBB765A
7-62
To Next Page
Loading...
