12. STATISTICAL MEASUREMENT
12.7 Loading the Statistical Data
The saved statistical data on the SD card can be loaded.
IMPORTANT
• When the statistical measurement is started, you cannot modify the condition settings.
Make sure to modify them before performing measurement.
To modify the condition settings, you need to delete all the statistical data.
• When the statistical data are loaded, the data are modified to that when the statistical
data are saved. The current conditions and data are deleted.
• When using the built-in battery, make sure it is sufficiently charged. When the statistical
data are loaded while the level of the battery remainder power is low, the power of the
SJ-410 may be turned off during loading of the data.
• Do not insert or remove the SD card while the SJ-410 is gaining access.
12.7.1 Loading the statistical data
■ Operating procedure (Refer to 12.2 "■ Accessing the Statistical Menu screen".)
Home screen to Main Menu ⇒ ⇒
Statistical Menu screen
1 Touch .
Statistical Data screen
2 Touch .
Condition File Load screen
3 Touch the statistical data to be loaded.
If the statistical file to be loaded is not displayed, touch
/ / / to display the statistical file.
No. 99MBB765A
12-13
To Next Page
Loading...
