Mitutoyo SURFTEST SJ-410 - Setting Calculation Conditions When Mr[C] (Tp for ANSI) Is Selected

No. 99MBB765A
8-14
8.3.4 Setting calculation conditions when mr[c] (tp for ANSI) is selected
If the parameter mr(c) (tp for ANSI) is selected, the slice level must also be set as a
calculation condition.
■ Operating procedure (Refer to 8.1 "■ Accessing the Parameter Setup screen".)
Home screen to Main Menu ⇒ ⇒
Details Setting screen
1
Touch （ for ANSI）.
mr(c) Setup screen
2
Touch the reference of the slice level to be selected.
"Peak": Set from the highest peak of the evaluation profile
"Base": Set from the mean line of the evaluation profile
 The background of the selected slice level reference
becomes blue.
mr(c) Setup screen
3
Touch the measurement type of the slice level to be selected.
 The background of the selected measurement type becomes
blue.
The set measurement type for the slice level will switch.
mr(c) Setup screen
4
Touch to accept the slice points.
Touching
cycles through the available number of
slice points, 1 or 2.