8. MODIFYING PARAMETERS
No. 99MBB765A
mr(c) Setup screen
Set the slice level.
If “slice points” is set to 2, two slice levels can be set.
a Touch or under "Slice points".
Slice Level Setup screen
b Input the slice level.
The input range is as follows:
When "Peak" is selected:
0.0 - 99.9%
0.0 - 9999.99 µm (39366.141 µm)
When "Base" is selected:
-50.0 - 50.0%
-9999.99 - 9999.99 µm (39366.141 µm)
TIP
• Touching sets the value to 0.
• For information about numeric value entry, refer to
"2.2.4 Entering numeric values/characters" (page 2-5).
mr(c) Setup screen
c Touch .
The set slice level is displayed on the setup screen for mr(c)
(tp for ANSI).
To Next Page
Loading...
