Mitutoyo SURFTEST SJ-410 - Setting the Auto-Start Function

7.5.6 Setting the auto-start function
Sets the auto-start function. The auto-start function can be set when automatic positioning
unit (optional accessory) is used for measurement.
Automatic
positioning
Measurement
Auto-start operation
TIP
• The auto-start function can also be set in the Drive Unit Operation screen. For
information about setting the auto-start function in the Drive Unit Operation screen, refer
to "5.5.2 Measurement using the automatic positioning unit" (page 5-13).
■ Operating procedure (Refer to
7.2 “■ Accessing the Evaluating Condition Menu screen”)
Home screen to Main Menu ⇒ ⇒ ⇒
Measurement Conditions Menu screen
1 Touch on the Measurement Condition Menu
screen.
Auto-start Setup screen
2 Touch on the Auto-start Setup screen.
Touching
cycles through the available settings,
ON and OFF.
No. 99MBB765A
7-54