Mitutoyo SURFTEST SJ-410 - Setting Calculation Conditions When ΔC (Htp for ANSI) Is Selected

No. 99MBB765A
8-16
8.3.5 Setting calculation conditions when δc (Htp for ANSI) is selected
If the parameter δc (Htp for ANSI) is selected, the slice level and reference line must also
be set as calculation conditions.
■ Operating procedure (Refer to 8.1 "■ Accessing the Parameter Setup screen".)
Home screen to Main Menu ⇒ ⇒
Details Setting screen
1
Touch ( for ANSI).
δc Setup screen
2
Touch to accept the slice points.
Touching
cycles through the available number of
slice points, 1, 2, or 3.
δc Setup screen
δc Setup screen
3
The number of reference lines to set matches the number of set
slice points.
Settings that cannot be made have a gray background.
a Touch the numeric button to set "Ref. Line".