Mitutoyo SURFTEST SJ-410 - Page 249

8. MODIFYING PARAMETERS
No. 99MBB765A
8-17
Reference Line Setup screen
b Input the reference line.
The input range is as follows:
0.0 - 99.9 %
TIP
• Touching sets the value to 0.
• For information about numeric value entry, refer to
"2.2.4 Entering numeric values/characters" (page 2-5).
δc Setup screen
c Touch .
 The set reference line is displayed on the setup screen for δc
(Htp for ANSI).
δc Setup screen
4
The number of slice levels to set matches the number of set slice
points.
Settings that cannot be made have a gray background.
a Touch the numeric button to set "SliceLv.".
Slice Level Setup screen
b Input the slice level.
The input range is as follows:
0.0 - 99.9 %
TIP
• Touching sets the value to 0.
• For information about numeric value entry, refer to
"2.2.4 Entering numeric values/characters" (page 2-5).
Slice Level Setup screen
c Touch .
 The set slice level is displayed on the setup screen for δc
(Htp for ANSI).