Mitutoyo SURFTEST SJ-410 - Parameter Detail Settings; Setting Calculation Conditions When Sm, Pc, Ppi, or Rc Are Selected

No. 99MBB765A
8-6
8.3 Parameter Detail Settings
Calculation conditions can be set as necessary for parameters such as Sm, Pc, Ppi, Rc,
HSC, etc.
8.3.1 Setting calculation conditions when Sm, Pc, Ppi, or Rc are selected
If the Sm, Pc, Ppi, or Rc parameter is selected, the height of the slice level, a calculation
condition, must be set. Profile Element restriction definition settings can also be made.
Profile Element restriction definition (when the height of the slice level is 10%)
(1) Zp / Zv ： Zp > Zmin, Zv > Zmin Zmin=10% of Rz
(2) Zt ： Zt>Zmin Zmin=10% of Rz
10% of Rz
Evaluation profiles
Mean line
10% of Rz or more
Peak
Peak
Valley
Valley
Peak
Peak
Peak
Valley
Valley
Valley
Evaluation profiles
Mean line