Mitutoyo SURFTEST SJ-410 - Page 237

8. MODIFYING PARAMETERS
No. 99MBB765A
8-5
Roughness
standard
Evaluation
profile
Parameter
Free P
Pa, Pq, Pz, Py, Pp, Pv, P3z,Psk, Pku, Pc, PPc, PSm, S, HSC, PzJIS, Pppi, PΔa, PΔq,
Pλa, Pλq, PLo, Plr, Pmr, Pmr(c), Pδc, Pt, Ppm, Rk, Rpk, Rvk, Mr1, Mr2, A1, A2,Vo
R
Ra, Rq, Rz, Ry, Rp, Rv, R3z, Rsk, Rku, Rc, RPc, RSm, S, HSC, RzJIS, Rppi, RΔa,
RΔq, Rλa, Rλq, RLo, Rlr, Rmr, Rmr(c), Rδc, Rt, Rpm, Rk, Rpk, Rvk, Mr1, Mr2, A1,
A2,Vo
DF
Ra, Rq, Rz, Ry, Rp, Rv, R3z,Rsk, Rku, Rc,RPc, RSm, S, HSC, RzJIS, Rppi, RΔa,
RΔq, Rλa, Rλq, RLo, Rlr, Rmr, Rmr(c), Rδc, Rt, Rpm, Rk, Rpk, Rvk, Mr1, Mr2, A1,
A2,Vo
R-Motif
R, Rx, AR
W-Motif
W, Wx, AW, Wte
W
Wa, Wq, Wz, Wy, Wp, Wv, W3z, Wsk, Wku, Wc, WPc, WSm, S, HSC, WzJIS, Wppi,
WΔa, WΔq, Wλa, Wλq, WLo, Wlr, Wmr, Wmr(c), Wδc, Wt, Wpm, Rk, Rpk, Rvk, Mr1,
Mr2, A1, A2, Vo
■ Operating procedure (Refer to 8.1 "■ Accessing the Parameter Setup screen".)
Home screen to Main Menu ⇒
Parameter Setup screen
1
Check that the roughness standard and evaluation
profile are
selected for the parameters to be customized.
When the roughness standard or evaluation profile differs, refer to
"7.3.1 Modifying the roughness standard" (page 7-
6) or "7.3.2
Modifying the evaluation profile" (page 7-7), and change the
roughness standard or evaluation profile accordingly.
Parameter Setup screen
2
Set the parameters.
Touch the parameter button to be calculated/displayed.
 The set parameter button turns blue.
Parameter Setup screen
3
Cancel a parameter setting.
Touch the parameter button to cancel.
 The canceled parameter button turns gray.
4 Repeat steps 2 and 3 to set all the parameters you wish to
calculate and display.
TIP
• When target parameter is not displayed on the
Parameter Setup screen, touch
/ to switch
the screen display.