Mitutoyo SURFTEST SJ-410 - Selecting the Displayed Parameters (Parameter Customization); Customizing Parameters

8. MODIFYING PARAMETERS
No. 99MBB765A
8-3
8.2 Selecting the Displayed Parameters (Parameter
Customization)
Parameter customization functions can be used to set what will be calculated and
displayed.
8.2.1 Customizing parameters
■ Overview of the parameter customization function
The instrument is initially set at the factory to calculate and display the most commonly
used parameters. For other parameters, you can use the parameter customization function
to specify their calculation and display settings.
By calculating and displaying only specified parameters, the time required to calculate of
measurement results is shortened, and the button operations for switching parameter
display, etc. can be simplified.
TIP
• The definition of each parameter is given in "23.5 Definitions of the SJ-410 Roughness
Parameters" (page 23-18).
• If the Sm, Pc, or Ppi parameter is selected, the height of the slice level must also be set.
Refer to "8.3.1 Setting calculation conditions when Sm, Pc, Ppi, or Rc are selected"
(page 8-6) for setting procedure details.
• If the HSC parameter is selected, the height of the slice level must also be set. Refer to
"8.3.2 Setting calculation conditions when HSC is selected" (page 8-9
) for setting
procedure details.
• If the mr parameter is selected, the number of sections, reference line, and section level
must also be set. Refer to "8.3.3 Setting calculation conditions when mr is selected"
(page 8-11) for setting procedure details.
• If the mr[c] parameter is selected, the section level must also be set. Refer to "8.3.4
Setting calculation conditions when mr[c] (tp for ANSI) is selected" (page 8-14
) for
setting procedure details.
• When the δc parameter is selected, the reference line and section level must also be
set. Refer to "8.3.5 Setting calculation conditions when δc (Htp for ANSI) is selected"
(page 8-16) for setting procedure details.