Mitutoyo SURFTEST SJ-410 - Setting Data Output to Save Data

No. 99MBB765A
13-8
13.4.2 Setting data output to save data
You can save calculation results and measurement data to the SD card when data output
is set to “Data storage”.
With this setting, calculation results and measurement data are saved to the SD card
when
of the SJ-410 is pressed.
NOTE
• The factory default setting for data output is “SPC”.
• Measurement data is saved in a designated folder that is set in "10.4.3 Specifying the
main folder" (page 10-12).
■ Operating procedure (Refer to 13.1, “■ Accessing the Operating Environment Setup screen”.)
Home screen to Main Menu ⇒
Operating Environment Setup screen
1
Touch .
Data Output Setup screen
2
Touch .