14. SWITCHING THE CALCULATION RESULTS SCREEN
14.3.2 Trace display
The SJ-410 saves measurement results up to 10 latest measurements for every
customized parameter.
The measurement results are displayed in the chronological order so that the latest
measurement result is displayed in the highest column on the screen.
When there are three or more columns lower than the second column, display can be
switched using
[Switch Results].
Only the latest measurement result can be saved on the SD card, printed, and output as
SPC data.
Trace screen
NOTE
• The result data of the measurements performed before the last 10 measurements will
be deleted in order from the oldest data.
• The trace data will be cleared if the Trace screen is refreshed.
• The trace data may be cleared if the measurement conditions are changed.
TIP
• For information about setting the Trace screen, refer to "14.3 Switching Calculation
Results screen
" (page 14-4).
■ Clearing the trace data
It is possible to clear all of the saved trace data.
Trace screen
1 Touch [Delete All Files] on the Trace screen.
¾ A message will be displayed to confirm that it is OK to clear
the trace data.
No. 99MBB765A
14-5
To Next Page
Loading...
