Mitutoyo SURFTEST SJ-410 - Switch the Parameter to be Displayed; Display the Evaluation Profiles

4.6.1 Switch the parameter to be displayed
When displaying the measurement results, the objective parameter to be displayed can be
switched to another customized parameter.
Each time
[parameter switching] is touched, the displayed parameter that has been
selected using the parameter customize function changes in the following order: Ra -> Rq
-> Rz -> XXX.
The objective parameters to be displayed are limited to the parameters that have been
customized using the parameter customize function.
TIP
• For information about the parameter customize function, refer to "8.2.1 Customizing
parameters" (page 8-3).
• For information about switching the display directions, displaying multiple parameters
on one screen, and trace display, refer to "14.3 Switching the Calculation Results
Screen" (page 14-4).
Switching the parameter display
4.6.2 Display the evaluation profiles
The measurement results can be displayed in the measured profile (evaluation profile).
The evaluation profiles can be zoomed in every direction and scrolled for display.
The evaluation profile can also be displayed in print magnification.
Touch
[Evaluation Profile] to display the Evaluation Profile screen.
Guidance button
Evaluation Profile screen
No. 99MBB765A
4-18