Mitutoyo SURFTEST SJ-410 - Setting the Data Output to Hard Copy

13. OPERATING ENVIRONMENT SETUP
No. 99MBB765A
13-9
13.4.3 Setting the data output to hard copy
You can perform an image capture of displayed calculation results when data output is set
to “Hard copy”.
With this setting, graphical data of the displayed calculation results image is saved to the
SD card when
of the SJ-410 is pressed.
NOTE
• The factory default setting for data output is “SPC”.
■ Operating procedure (Refer to 13.1, “■ Accessing the Operating Environment Setup screen”.)
Home screen to Main Menu ⇒
Operating Environment Setup screen
1
Touch .
Data Output Setup screen
2
Touch .