Mitutoyo SURFTEST SJ-410 - Replacing the Built-In Battery Pack

20. MAINTENANCE AND INSPECTION OF THE SJ-410
No. 99MBB765A
20-3
20.2 Replacing the Built-in Battery Pack
■ Replacing the built-in battery pack procedure
A replacement of the battery pack can be purchased from your SJ-410 dealer.
- Replacement of the battery pack
Part No.
Number of
pieces
12AAN046 1
IMPORTANT
• Follow the directions given below and exercise care when replacing the built-in battery
pack not to break or damage the display unit or cable.
NOTE
• The battery pack replacement should be done where there is as little dust and other
shop contamination as possible. In addition, exercise care so that dust or oil mist does
not penetrate the display unit. A malfunction may result if dust or shop contamination
soils inside the display unit.
• When the built-in battery pack is replaced, the saved measur
ement results and
condition settings will be cleared. Necessary data must be printed or saved to the
memory card before replacing the built-in battery pack.
1 Turn the display unit off.
2 When an AC adapter is used, disconnect the AC adapter plug from the display unit.
3 Set the built-in battery switch at the rear of the display unit to OFF.