7. MODIFICATION OF THE MEASUREMENT CONDITIONS AND EVALUATING CONDITIONS
7.3.8 Deleting unnecessary data
Unnecessary data can be deleted and recalculation can be performed for the reason of
outlier removal, etc.
There are 2 ways of deleting: in-cutoff and out-cutoff.
In-cutoff: The selected range is not calculated.
Out-cutoff: Only the selected range is calculated.
IMPORTANT
• If unnecessary data is deleted, the calculation result is meant as reference because it is
not obtained from continuous data. In this cas
e, “ C” is appended to the displayed
calculation result.
■ Operating procedure (By in-cutoff) (Refer to
7.2 “■ Accessing the Evaluating Condition Menu screen”)
Home screen to Main Menu ⇒ ⇒
Evaluating Condition Menu screen
1 Touch on the Evaluating Condition Menu screen.
Waveform Deletion Setup screen
2 Touch , then touch .
In-Cutoff Setup screen
3 Touch [Ruler Display].
TIP
• For information about waveform scroll, refer to "4.6.2
Display the evaluation profiles" (page 4-18).
No. 99MBB765A
7-31
To Next Page
Loading...
