Mitutoyo SURFTEST SJ-410 - Restoring Factory Default Settings

13. OPERATING ENVIRONMENT SETUP
No. 99MBB765A
13-53
13.20 Restoring Factory Default Settings
You can reset all settings in the SJ-410 to their original values (factory default settings).
IMPORTANT
• Care must be exercised when resetting to the factory-set defaults. When the SJ-410 is
reset, all of your set measurement conditions, etc. are lost.
• Drive unit type settings, calibration information, decimal point settings and language
settings remain unchanged.
For information about the contents of the factory default settings, refer to "13.20.1 Items
restored to original values when restoring factory default settings" (page 13-54).
■ Operating procedure (Refer to 13.1, “■ Accessing the Operating Environment Setup screen”.)
Home screen to Main Menu ⇒ ⇒
Operating Environment Setup screen
1
Touch .
Reset to Default screen
2
Touch .
To cancel the reset operation, touch
.
 All initial settings are restored.
When the settings are reset, the Calculation Results screen
appears.