Mitutoyo SURFTEST SJ-410 - Hard Copying the Screen; Automatic Printing after Completing Measurement; Stylus Alarm

No. 99MBB765A
17-4
NOTE
• This functions is available only when a SD card is inserted.
• The result data of the measurements performed before the last 10 measurements will
be deleted in order from the oldest data.
• After the power to the instrument is turned on, the first time data is saved may take more
time than usual.
TIP
• For information about setting the Save10 function, refer to "13.12.7 Setting the Save10
function" (page 13-36).
•
For information about loading measurement data which has been saved using the
Save10 function, refer to "10.3 Loading Measurement Results from the SD Card" (page
10-5).
17.8 Hard Copying the Screen
The displayed screen image can be saved as BMP data to the SD card.
The image data are saved in the "IMG" folder on the SD card's "SJ-410" folder.
The image data can be transferred to a personal computer using communication software
or a third-party SD card reader.
TIP
• For information about setting the hard copying of the screen, refer to "13.4.3 Setting the
data output to hard copy" (page 13-9).
• The camera icon（ ）is indicated on the upper screen during hard copy screen mode.
17.9 Automatic Printing after Completing Measurement
If the auto-print function is enabled, a measurement result can be printed when a
measurement is completed.
TIP
• For information about the Auto-
print, refer to "13.5.1 Setting the print items" (page
13-10).
17.10 Stylus Alarm
The stylus alarm function cumulates the measured lengths, and displays the message if
designated threshold value exceeds the cumulative distance.
TIP
• For information about setting the Stylus Alarm, refer to "6.6 Setting the Stylus Alarm"
(page 6-19).
• A message will be displayed every time the power is turned on. Set the setting of the
threshold to 0.0 if you want the message non-displayed.