Mitutoyo SURFTEST SJ-410 - Plugging;Unplugging the Connection Cable

No. 99MBB765A
3-12
3.3.2 Plugging/unplugging the connection cable
IMPORTANT
• These connections (or disconnections) should be made while the power to the SJ-410 is
off.
To use the SJ-410, connect the drive/detector unit and display unit with the connection
cable.
■ Plugging in and unplugging the connection cable
Plug in and unplug the connection cable as shown below:
Connection cable
• Connecting the display unit and connection cable
Confirm the orientation of the connector, and insert the connector into the display unit.
• Disconnecting the connection cable from the display unit
Pull out the connector while firmly pressing sections A with your fingers.
A
A
Connection
cable
Drive/detector
unit
Display unit
Connector