7.3.2.4 Modifying cut-off length (λf, λc) of the waviness profile W
When the waviness profile W is selected, the cut-off length (λf and λs) are displayed as
cutoff-related variable parameters on the Evaluating Condition Setup screen. Change
cut-off length (λf, λc) if required.
■ The relationship between the cut-off lengths (λf) and (λc)
When a cut-off length (λf) is set, the following settings are allowed for the cut-off length
(λc):
Cut-off length (λf) Cut-off length (λc)
0.25 mm (0.009 in) 0.08 mm (0.003 in)
0.8 mm (0.031 in) 0.08 mm, 0.25 mm (0.003 in, 0.009 in)
2.5 mm (0.098 in) 0.08 mm, 0.25 mm, 0.8 mm (0.003 in, 0.009 in, 0.031 in)
8 mm (0.314 in) 0.08 mm, 0.25 mm, 0.8 mm, 2.5 mm (0.003 in, 0.009 in, 0.031 in,
0.098 in)
■ Operating procedure (Refer to
7.2 “■ Accessing the Evaluating Condition Menu screen”)
Home screen to Main Menu ⇒
Evaluating Condition Menu screen
1 Touch on the Evaluating Condition Menu screen.
Evaluation Profile Setup screen
2 Touch in the Evaluation Profile Setup screen,
then touch
.
No. 99MBB765A
7-14
To Next Page
Loading...
