3.8 Using the SD Card
With the SJ-410, the condition settings and measurement data can be stored on the SD
card. To use the SD card, you must set the SD card to the SJ-410.
• The SD card or SDHC card is used as the memory card. The microSD card or
microSDHC card is also available. When using the microSD card or microSDHC card,
use the adapter.
SD
TM
SDHC
TM
and microSD
TM
microSDHC
TM
are the registered trademark of the SD
Association.
In this manual, the above cards are described as "SD card" in short form partly.
• Before using the SD card with the SJ-410, the card must be formatted using the SJ-410
main unit. When the SD card is formatted, all of its SJ-410 data are erased. For
information about formatting the SD card, refer to "13.12.3 Formatting the SD card"
(page 13-31).
• Connect the AC adapter to prevent power to the instrument from being interrupted while
making settings.
• When using the built-in battery, make sure it is sufficiently charged. If operations are
performed when the battery power is low, the SJ-410 may shut off during operation.
• Do not remove the card during operation.
• No warranty is given in regrads to operation using the cards described above.
To Next Page
Loading...
