7 MODIFICATION OF THE
MEASUREMENT
CONDITIONS AND
EVALUATING CONDITIONS
Measurement conditions are set or modified according to surface
roughness parameters, degree of roughness, conditions of the
location measured, etc.
The SJ-410 is compatible with each of the following roughness standards: JIS1982,
JIS1994, JIS2001, ISO1997, ANSI, and VDA.
Referring to "Chapter 23 REFERENCE INFORMATION" (page 23-1), set up the
measurement conditions according to the roughness standard to be complied with.
7
■ About modifying the conditions
Since measurement condition items to be set according to the standard are interrelated,
setting a condition may also determine some other relevant conditions within the SJ-410.
For information about the relationship between the measurement condition items refer to
“
7.3.1 Modifying the roughness standard” (page 7-6) to “7.5.3 Modifying the measuring
range
” (page 7-51).
For some conditions, some choices may not be available due to being fixed for that
standard, or because of other conditions. Related icons on the touch panel do not function.
No. 99MBB765A
7-1
To Next Page
Loading...
