Mitutoyo SURFTEST SJ-410 - Page 242

No. 99MBB765A
8-10
Sm/Pc/Ppi/Rc Setup screen
 The background of the selected measurement type becomes
blue.
The set measurement type for the height of the slice level will
switch.
Sm/Pc/Ppi/Rc Setup screen
4
Setting the height of the slice level.
a Touch .
Count Level Setup screen
b Input the height of the slice level.
The input range is as follows:
When "Peak" is selected:
0.0 - 99.9%
0.0 - 9999.99 µm (39366.141 µm)
When "Base" is selected:
-50.0 - 50.0%
-9999.99 - 9999.99 µm (39366.141 µm)
TIP
• Touching sets the value to 0.
• For information about numeric value entry, refer to
"2.2.4 Entering numeric values/characters" (page 2-5).
Count Level Setup screen
c Touch .
 The set height of the slice level is displayed on the HSC
Setup screen.