Mitutoyo SURFTEST SJ-410 - Page 410

No. 99MBB765A
16-8
Analyze Coordinate Difference screen
2
Touch a place to set the ruler 1.
To adjust the ruler position, touch
/ .
Analyze Coordinate Difference screen
3
Touch [Switch Ruler].
 The ruler 2 is selected and
(red) is displayed above.
Analyze Coordinate Difference screen
4
Touch a place to set the ruler 2.
To adjust the ruler position, touch
/ .
 The coordinate difference is displayed on the screen.
■ Specifying the X-coordinate by entering the values
(Refer to 16.1 "■ Accessing the Analyze Waveform screen".)
Home screen ⇒ [Evaluation Profile] ⇒ [Analyze Waveform]
Analyze Waveform screen
1
Touch .
NOTE
• When R-Motif or W-Motif is selected for a profile motif,
the coordinate difference cannot be analyzed.