Need help?Do you have a question about the Mobatime EuroTime Center ETC 24R and is the answer not in the manual?
General instructions for safe operation and long life of the device.
Warnings regarding opening the device, unauthorized access, and child safety.
Advice on avoiding moisture, dust, heat, direct sunlight, and ensuring air circulation.
Instructions for connecting power, including safety precautions and cable requirements.
Guidance on resolving malfunctions and contacting the supplier for repairs.
Specifies where to find connection details for mains power and other connections.
A list of steps for safe and fast initial setup of the ETC device.
Provides an example of navigating the ETC menu to change configuration values.
Information on connecting to mains power for different ETC models, including voltage and current.
Explains synchronization using the DCF-77 long wave time signal.
Instructions for manually setting time and date when no external reference is connected.
Selection of the external time source for synchronizing the master clock.
Lists the 16 possible alarms identified by letters A to P.
Configuration options for impulse lines, including line state, time, date, mode, and periodicity.
Operation and configuration of MOBALine for self-setting slave clocks, including line mode and time zones.
Defines parameters like Baudrate, Data Bits, Stop Bits, and Parity for data transmission.
A practical example showing illumination control with a twilight switch.
A table of malfunctions and their possible causes and actions.
Procedure to reset the master clock to initial factory settings.
General| Category | Clock |
|---|---|
| Housing | Metal |
| Time Synchronization | NTP, GPS, DCF77 |
| Output | RS232, RS485 |
| Mounting | 19-inch rack |
| Display | LCD |
| Frequency | 50 Hz |
| Dimensions | 483 x 44 x 250 mm |
To Next Page
