MobiCom GL600 - Page 15

Mobicom Telematics –GL600 GPS Smart Lock User Guide
15 / 20
Copyright © 2019 Shenzhen Mobicom Telematics Co.,Ltd. All rights reserved.
http://maps.google.com/
?q=22.549737,114.076
685
Internal Battery Level: Battery:85%
Number of captured satellites: GPS:3
Lock status: Lock close/open
Google Map Link:
http://maps.google.com/?q=22.549737,114.07668
5
6
Unlocking device by
Password
(P43,888888)
888888 is the default password
(7570101998,P43,0,2)
“0” means failed,“1” means successfully,
2：means continuously input wrong password
times,
7
Change Unlock
Password
(P44, 123aAM,888888)
123aAM is the new password
888888 is default password
(7570101998,P44,1)
1 means change password successfully; 0 means
unsuccessfully
8
Add /Remove unlocking
authorized RFID ID
1.add 10 RFID tags numbers, use
below command :
(P41,1,1,10,0000112345,00002
12345,0000312345,0000412345,0
000512345,0000612345,00007123
45,0000812345,0000912345,0000
012345)
1 means add
10 total 10 RFID tags .
2.remove all authorized RFID tags
in device
(P41,1,3)
9
Restart Device
(P15)
(7570101998,P15)
Device will restart itself after 30 sec
10
Set the Time Zone
(only effect SMS
content)
(P10,1,480)
480：time zone. Unit is minute.
Eg. Beijing time is 8 hour different
from GMT 0, 8 hr means 480 min.
value range is -12*60 to 13*60，in
default is ‘0’
(P10,1,-180)
(7570101998,P10,480)
11
Restore Factory
setting of device
(P13)
Except for IP address, VIP
numbers, APN, APN account &
password, all parameters will be
factory defaults.
(7570101998,P13)