ML30, ML40 Cleaning and maintenance
17
Replacing the interior light
➤ Disconnect the device from the mains.
➤ Open the transparent cover using a screwdriver.
➤ Loosen the mounting screws of the circuit board.
➤ Pull the plug out of the circuit board.
➤ Replace the faulty circuit board with a new one.
➤ Reinstall the circuit board and the transparent cover.
8 Cleaning and maintenance
!
A
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any
dust and dirt, so that heat can be released and the device is not damaged.
WARNING!
Always disconnect the device from the power supply before you
clean and service it.
NOTICE! Risk of damage
Never clean the cooler under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
ML30-ML40-O-16s.book Seite 17 Freitag, 28. April 2017 12:02 12
To Next Page
Loading...
