Warranty ML30, ML40
18
9Warranty
The statutory warranty period applies. If the product is defective, please
contact the manufacturer's branch in your country (see the back of the
instruction manual for the addresses) or your retailer.
For repair and guarantee processing, please include the following docu-
ments when you send in the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
10 Disposal
➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
M
If you wish to finally dispose of the product, ask your local recycling
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
11 Troubleshooting
Problem Cause Remedy
The device does not cool
(cooling element is cold).
The device is not con-
nected to a power supply.
Connect the device.
Circuit breaker or fuse has
blown.
Switch on the circuit
breaker; switch on or
replace the fuse.
There is a defect in the
electronics or the heating
element.
This can only be repaired
by an authorised repair
centre.
The device does not cool
(cooling element is
warm).
The device is not level. Make sure the device is
level by adjusting the feet.
The device was con-
nected only briefly.
Connect the device and
run it for 5 to 6 hours.
There is a defect in the
cooling element.
This can only be repaired
by an authorised repair
centre.
ML30-ML40-O-16s.book Seite 18 Freitag, 28. April 2017 12:02 12
To Next Page
Loading...
